Common Faults And Solutions When Using Pneumatic Ball Valves?

Many companies will use 2 Piece Threaded Ball Valve. By using pneumatic ball valves, the relevant problems of the company can be effectively solved. However, in the process of using pneumatic ball valves, some problems are also easy to occur. In order to better use pneumatic ball valves, the following editor will briefly introduce the common faults and solutions of pneumatic ball valves.

1. Pneumatic ball valve leakage

In the process of using pneumatic ball valves, various faults are easy to occur. The most common is the leakage of pneumatic ball valves. If this happens, it is likely caused by the aging of the sealing ring at the connection of the valve stem. To solve this problem, you only need to replace the sealing ring.

2. Pneumatic ball valve has no feedback signal

When there is no feedback signal from the pneumatic ball valve, you can check whether there is a problem with the circuit. Use a multimeter to detect the signal line connected to the power supply. If the signal line is damaged, you can replace the signal line.

3. The positioner cannot work properly

When the positioner of the pneumatic ball valve cannot work properly, it is likely that the pneumatic ball valve is not closed to zero position. You only need to close it to zero position.

After reading the above content, I believe everyone has learned about the common faults and solutions of pneumatic ball valves. In order to make the pneumatic ball valve work better for the enterprise, it is necessary to check it in time during the use of the pneumatic ball valve. If any problems are found, they need to be repaired and handled.